Configure the Microsoft Dynamics AX Connector
The Microsoft Dynamics AX Connector transmits data among components and the Microsoft Dynamics AX enterprise software.
Prerequisite: To configure this connector, Microsoft Dynamics AX and ScanworkX Server must already be installed. Additionally, the required licenses must be installed.
To configure the Microsoft Dynamics AX Connector, complete the following steps in Advanced Inventory Platform Manager.
-
Go to Admin > Configuration > Connector Settings page.
-
From the list of connectors, choose the Microsoft Dynamics AX Connector.
-
If the system interfaces with multiple enterprise environments, also choose the environment for which to configure the connector.
-
For Dynamics AX connector, enter the name of the computer serving as host to the Dynamics AX AOS system. This value must be specified based on the particular configuration.
-
For Dynamics AX WSDL port, enter the network port on which the host computer communicates with the server. This port number is specified in the Dynamics AX connector install. The default port number is 8201.
-
For Dynamics AX UPN, enter the User Principal Name that is used by Dynamic AX when managing profiles and permissions. Additionally this needs to be a ScanWorkX user.
-
For Dynamics AX UPN domain, enter the User Principal Name domain that the Dynamics AX system uses when managing profiles and permissions.
-
For ScanWorkX host name, enter the name or IP address of the computer serving as host to the system to which requests are sent. This value must be specified based on the particular configuration.
-
For ScanWorkX port, enter the network port on which the host computer communicates with the server. This port number is specified in the ScanWorkX install. The default port number is 20001.
-
Select Log request/response documents, to specify that request/response documents are logged to the Logging folder in the installation. The document name format to which they are logged is: Microsoft Dynamics AX_(GUID).txt (The GUID section will vary). This is a transaction ID which should be unique.
-
For Time-out (sec), enter the amount of time (in seconds) to wait for a reply from the web service when sending a request. A default value is provided; however, it can be changed. Entry in this numeric field can range from 5 to 300 seconds.
-
Select Save.
Loading...
There was a problem loading this topic